Free UK Delivery* Available

Brush Pile Grey Draught Brush Gasket Seal for Upvc 4.8mm x 12mm High

In stock

Buy More Save More!

  • Order 3-5 save 5%
  • Order 6-9 save 10%
  • Order 10+ save 15%
  • Large Stock
  • Free UK
  • Expert

Grey Brush Pile Draught Gasket Seal Suits Stormguard Low Threshold Also Composite and Sliding Patio Doors 4.8mm Base 12mm High 

This narrow base 4.8mm wool pile draught gasket can be used to replace the worn out or damaged gaskets commonly found on Stormguard Low Aluminimum threshold  & also composite doors Upvc inline sliders and also vertical sliding window frames. The gasket slides into the groove in the profile system and when fitted correctly in place will remain in situation for years of trouble free installation.

Provides a draught tight seal to Upvc windows and doors. The wool pile draught strip gasket is able to be highly compressed therefore enabling it to cover the many different gap seals required to suit the rebate systems that have been used in the double glazing industry over the last 2 or 3 decades and that are now impossible to find the original gaskets for. This is sold in 1 metre increments and will be cut into one continuous length.

Sold in 1 metre increments therefore if you require 10 metres you would order a quantity of 10.

  • Overall height: 12mm
  • Width of plastic shoe: 4.8mm
  • Thickness of plastic shoe: 0.75mm

Fitting tip:

If you are retro fitting this gasket then you will need to cut a slot at one end of the profile, about 50mm from the end, and feed the plastic shoe into place. Once you have slid it down the long length, cut the gasket 70mm longer and feed it up the short bit (the 50mm end) and the 20mm extra length. Keep the full gasket tight up to each end if you are worried about it popping out, a tiny blob of superglue on the plastic shoe will hold it in place.

More Information

More Information


Write Your Own Review
You're reviewing:Brush Pile Grey Draught Brush Gasket Seal for Upvc 4.8mm x 12mm High
Your Rating